4 ounce Mesri red curry paste, nine 3/64" holes (angled for vortex)
Febreze(R) air freshener can, outer cylinder nine 1/8" holes, inner cylinder 9 creases ending at 1/8" holes in outer cylinder
I ram swaged the outer cylinder over the top and bottom of the air freshener can, using water soluble lubricant. Then I added the creases to the inner cylinder (can bottom). The top of the outer cylinder is scalloped to minimize heat loss to the pot, and vent fuel vapors originating inside the inner cylinder.
I'm hoping most of the fuel vaporizes between the two cylinders, passes through the creases, then the 1/8" holes, and finally the 3/64" holes.
The post was edited 1 time, last by WanderingStovie ().